Common problems and solutions when use Shrink sleeve labeling machines
Shrink sleeve labeling machines in the use process prone to the following questions To solve these problems, we have made a special solution, only for reference:
Shrink film is easy to plot in the center column material
Causes:
● Shrink bad;
● Shrink the size of the center column of the design and size do not meet;
● labeling machine is not adjusted.
Solution:
● Select the high stability, good adjustment and shrink the size of the error of allowing a high degree of labeling machine;
● the factory shrink film quality control.
Sleeves are not allowed
Causes:
● labeling machine is not adjusted;
● Shrink static electricity.
Solution:
● Select the high stability, good adjustment and static low shrink sleeve labeling machine;
● strengthening the operator's technical training;
● use of static elimination equipment.
Blade is easy to cut to the center column, resulting in blade fracture
Causes:
● Center Column not properly installed;
● Shrink plot in the center column material.
Solution:
● Select the high stability, shrink film is not easy to plot in the center column material sleeve machine;
● Select the center column is easy to install, and you want to wheel clamping center column sleeve machine. (Some brands of sets of non-standard machine wheel clamping center column, must be relaxed to a certain degree of success sets mark) as only relax without clamp, cutter and the center column will result in an incorrect position.
Shrink cut off position is not flat, a flash:
Causes:
● shrink size is greater than the center column of the design size;
● tip is not sharp;
● Blade level is not correct.
● Shrink size control;
● replace the blade;
● Use a good blade horizontal labeling machine.